Ball nose end mill
1:Co(%): 10-13
2:WC ncl Daping(%): 87-90
3:HRC: 91.8-92.4
4:Bending force: (N/mm): 3600-4000
5 :Coated with TISIN-S
6:HRC Can Reach45 - 65 Degree
7:Size:3mm-30mm customized is aviliable
Three flutes provide better chip-carrying capacity than four flutes and a finer finish than two, reducing the need for a second finishing cut in some applications.
Titanium aluminum nitride (TiAlN) coating lubricates the end mill for high-temperature stability and abrasion resistance at high cutting speeds, offering better heat resistance than TiN and TiCN coatings.
Carbide can run at higher speeds than high-speed steel, offering increased wear resistance at high cutting temperatures.
Ball nose end mills (also called ball end) create contoured surfaces.
Center-cutting design allows mill to plunge into material like a drill bit while also performing conventional surface milling.
Titanium aluminum nitride (TiAlN) coating lubricates the end mill for high-temperature stability and abrasion resistance at high cutting speeds, offering better heat resistance than TiN and TiCN coatings.
Carbide can run at higher speeds than high-speed steel, offering increased wear resistance at high cutting temperatures.
Ball nose end mills (also called ball end) create contoured surfaces.
Center-cutting design allows mill to plunge into material like a drill bit while also performing conventional surface milling.
www.lysmanufactory.com
No comments:
Post a Comment